13
OPERATING THE 4X4 HDMI OVER CAT5 RECEIVER
To use the 4x4 HDMI Over CAT5 Receiver, the following connections must be
made:
1. A HDMI jumper cable is connected between the HDMI output port and the
HDMI extension input port.
2. The DDC and Video CAT-5e cable must be connected between the 4x4
HDMI Over CAT5 Matrix and the 4x4 HDMI Over CAT5 Receiver.
3. A HDMI display is connected to the 4x4 HDMI Over CAT5 Receiver.
4. The included power supply is connected to the 4x4 HDMI Over CAT5
Receiver.
Once these connections are properly made, the 4x4 HDMI Over CAT5 Receiver
can be used to select which HDMI source will be viewed on the connected
display. To select a HDMI source the direct input buttons located on the top panel
of the 4x4 HDMI Over CAT5 Receiver.
Button A selects HDMI Input 1
Button B selects HDMI Input 2
Button C selects HDMI Input 3
Button D selects HDMI Input 4
Switching can also be done using the included IR remote control or via the
RS-232 serial control interface.
NOTE:
Switching of HDMI sources is limited to the one display that is connected
to a particular 4x4 HDMI Over CAT5 Receiver. For example, it is not possible to
switch a HDMI source on a display connected to HDMI output 2 with the remote
at the display location of HDMI output 1. Switching of any local displays that are
not being extended or are not using a 4x4 HDMI Over CAT5 Receiver is limited to
the RS-232 serial control interface from the 4x4 HDMI Over CAT5 Matrix.
IR Blaster Functionality
To control HDMI sources from the remote location, a optional IR blaster (Part#
EXT-2IREMIT) can be attached for each 4x4 HDMI Over CAT5 Receiver on the
4x4 HDMI Over CAT5 Matrix. IR remote control commands can then be relayed
from each receiver to the device(s) connected to the blaster from the 4x4 HDMI
Over CAT5 Matrix.
