Gefen EXT-HDMI-2-COMPSVIDSN, Руководство пользователя

Страница: 9 / 18

5
INTRODUCTION
Panel Description s
1 L/R
Connect two RCA-type cables from these outputs to the display, audio amplifier, or
receiver. Only 2 channel LPCM from the HDMI input can be passed to these outputs.
Multi-channel bit-stream such as Dolby Digital will not be passed to this output.
2 Composite
Connect an RCA-type cable from this output to the Composite input on the display
or A/V receiver.
3 S-Video
Connect an S-Video cable between this output and the S-Video input on the display
or A/V receiver.
4 Coax Out
Connect an RCA-type cable from this output to the S/PDIF connector on a receiver or
audio amplifier.
5 PAL / NTSC
Switches between NTSC (60Hz) and PAL (50Hz) output. Make sure that you use the
proper output for the television. Using the wrong format will result in a unrecognizable
picture and may damage your television.
6 Under Scan / Over Scan
Most analog television sets were designed to accept an over-scanned signal. If the
resulting video signal displays a black border around the edges, then set this switch to
Over Scan. If the resulting video signal is stretched beyond the edge of the display, then
set this switch to Under Scan.
7 HDMI In
Connect an HDMI cable from the Hi-Def source to this connector.
8 USB
Used to upgrade the firmware. See page 10 for information on upgrading the firmware.
9 5V DC
Connect the included 5V DC power supply to this receptacle.
10 Power
This LED will glow bright blue once the included power supply is connected between the
scaler and an available electrical outlet.