Gefen EXT-DP-CAT7, Руководство пользователя

Страница: 12 / 24

8
CONNECTING THE DISPLAYPORT EXTENDER OVER CAT-7
Connections
1. Use the included DisplayPort cable to connect the DisplayPort source to the DP In
port on the Sender unit.
2. Connect the display to the Receiver unit using a DisplayPort cable.
3. Connect two CAT-7 cables between the Sender and Receiver units. Each connector
on the Sender and Receiver unit is identified as Link 1 and Link 2 . When connecting
the CAT-7 cables, make sure that each CAT-7 cable that is connected to the Sender
unit is connected to the corresponding jack on Receiver unit (e.g. Link 1 --> Link 1,
Link 2 --> Link 2).
4. Connect the included 5V DC locking power supply to the Sender unit. Do not
overtighten the locking connectors. Plug the AC power cord from the power supply
to an available electrical outlet.
Wiring Diagram
NOTE: The DisplayPort Extender over CAT-7 will support resolutions
up to 1920 x 1200 (WUXGA) and 1080p Full HD if only a single
CAT-7 cable is used. Two CAT-7 cables must be used to support
resolutions up to 2560 x 1600.
If only a single CAT-7 cable will be used, the CAT-7 cable must
be connected between the Link 1 connectors on both the Sender
and Receiver unit. This same CAT-7 cable is used to power the
Receiver unit.
EXT-DP-2CAT7
Sender
Receiver
DisplayPort Display
CAT-7 CABLE
Computer
DISPLAYPORT CABLE