Geemarc DALLAS10, Руководство пользователя

Страница: 4 / 28

3
1 - CONNECTING TELEPHONE
1 - Connect the handset cord.
2 - Connect the line cord to the socket located at rear of
telephone then connect the PTT plug*.
2 - RINGER SETTINGS
A switch located on right side allows the ringer to be
switched On ( ) or Off ( ).
3 - WALL MOUNTING
To wall-mount your telephone, slide out the clip turn
around and slide back into the wall mounting position
(located in the base unit, just below the ear piece).This
will ensure that the handset stays firmly in position.
Make 2 holes in the wall 85mm apart, insert the wall
plugs and the wall mounting screws. The screws should
protrude from wall by 6-7mm. Place the phone onto the
screw-heads and slide down to secure.
4 - TONE/PULSE SWITCH (T/P)**
The Tone/Pulse switch is factory pre-set to Tone
position (
T
).In the UK, all telephone exchanges now use
Tone dialing. If your phone does not dial out it is
probably being used from an older private switch board
(PBX). In this case, the Tone/Pulse switch must be
moved to Pulse (
P
).
SETTING UP