Page 15 (Revision 1.0) Copyright © 2018 GeeTramp® All Rights Reserved.
CARE AND MAINTENANCE INSTRUCTIONS
Maximum User Weight Limit
The trampoline has been designed to allow for the safe use by a single person at a time. It is recommended
that the user does not exceed the maximum user weight rating (see Maximum User Weight section).
Pre-Use Checks
The pre-use checks in this manual will highlight any ongoing repairs required or items to be addressed that
will preserve the life of the Mini Tramp. See the following for some additional ongoing care tips.
Frame
The frame works best on a level surface; if the Mini Tramp
is used on a surface that’s not level the frame will
need to absorb uneven localised loads that could be above the design capacity. Ensure the leg bottoms are
on the ground evenly to keep the loads evenly distributed.
Frame Corrosion
The steel parts are primarily protected from corrosion by a powder coated finish on top of a galvanised
coating, this, however, can be affected by some substances e.g. some soils are very acidic, salt mist can be
corrosive. The galvanised layer is, by design, a sacrificial coating and a scratch through this surface to the
base steel will still be protected. Any deterioration of a damaged area of the galvanised coating can be
prevented further by applying a suitable aftermarket spray paint.
Bed (Mat) & Pads
Residual substances from salt water, dust storms, chemical spraying, etc. on the Mini Tramp surface can
cause rapid wear or create an abrasive surface for the user, simply wash off with cold water and let it dry
before using the Mini Tramp. Be aware if the pads are not in place the edge stitching on the mat becomes
fully exposed to the sun
’
s UV, reducing mat lifespan.
Bed (Mat) Use
The bed and suspension system are designed to last well if most of the jumping is primarily done in the
centre and is not overloaded. Abrasive items like dirt or sand accelerate wear if on the bed while jumping.
Date of Purchase
Record your purchase date here
……………/……………/………………
Note: The Mini Tramp components deteriorate naturally with use and time in the environmental conditions
such as sunlight, rain, salt and heat. Also bear in mind that unexpected mishaps from misuse, transporting,
extreme weather and other causes can have an immediate effect on the safe condition of the Mini Tramp. It
is important that you inspect the Mini Tramp before each use and replace any worn, defective or missing
parts before further use. Use only parts that are recommended by the manufacturer. Consider below when
doing pre-use or regular maintenance checks.
Potential Hazards of Mini Tramp Components
Mini Tramp Frame
Mini Tramp Bed (Jumping mat)
Frame Padding
Bending or fracture of the
frame.
Punctures, holes, fraying, tears in the
bed or edge system.
Padding partially or completely
missing.
Loose joins, fasteners or
un-sturdy framework.
Stitching or fabric deteriorating of the
bed and its edge system.
Padding insecurely attached or
not positioned correctly.
Sharp protrusions on the
frame.
Sagging of the bed.
Damage, punctures, frays, tears
or holes in the padding.
Broken, missing or over
stretched springs.
Sharp protrusions in the suspension
system elements e.g. damaged or
broken springs.
Stitching or padding fabric
deteriorating of the padding and
its securing system.
