GEDA Odin 65, Руководство пользователя

Страница: 18 / 20

geda grill
Output 1 - Hot Rod (230V 200W)
Output 2 - Auger Motor (230V 20W)
Output 3 - Fan Motor (230V 20W)
Output 4 - Probe and grill temperature display
OPERATION FLOW
Step 1.
The power cord is connected. At this point, LCD screen is turned on and will flash 3 times, then the
LCD display is powered off.
Motor, fan and hot rod are kept off.
Step 2.
Press ON/OFF button, which powers the grill on. LCD display will turn on and the grill will begin its
Startup Cycle.
Motor, fan and hot rod will automatically activate during Startup Cycle.
The whole Startup process takes 6 minutes. If the grill is successfully ignited, it would
automatically begin it’s Running Cycle.
STARTUP
After the initial Startup Cycle begins, the temperature dial can be adjusted without
resetting the Startup Cycle.
1. The hot rod heats up within 6 minutes.
2. The auger motor runs a total time of 3,5 minutes.
3. The fan runs for 6 minutes.
At the end of the Startup Cycle, the RTD sensor would automatically run a temperature check inside
of the grill. The startup process is successful if the temperature is increased by more than 20°C or the
temperature exceeds 55°C. If the grill fails the Startup process, it will automatically restart from step
1.
The geda grill will attempt the startup cycle a total of 4 times. If any of the following temperature
changes accurse: grill temperature is increased by 20°C or internal temperature reaches 55°C the grill
will start its Running Cycle. If the grill fails to start the Running Cycle after 4 attempts, the display will
show “Er2”.
The auger motor, fan and hot rod will shut down automatically.
Step 3.