Gecko GEK-30G, Руководство пользователя

Страница: 10 / 16

12V/24V Portable Fridge/Freezer
E&OE © 2020 Gecko 10
Error Codes
E0
NTC fault alarm. Light is red.
E1
Cause : Low input voltage.
Solution : Check the
battery’s voltage and lower the battery’s protection level.
E2
Cause : Cooling fan blocked or short-circuited.
Solution : Inspect the cooling fan.
E3
Cause : Compressor has a high starting pressure.
Solution : Turn OFF the fridge/freezer for 30 minutes, then restart again.
E4
Cause :
Compressor’s speed is very slow.
Solution :
Adjust the control plate to change the compressor’s speed.
E5
Cause : Compressor control box temperature is too high.
Solution : Move the fridge/freezer to a well-ventilated location and wait for the temperature to decrease.
NOTES :
•
Definition of working mode: “HH” is an automatic control mode. When working mode is set to “HH,” the
compressor speed is an automatic control system with automatic switching between low and high speed.
•
High and low conversion rules of automatic control mode:
−
Low speed 2 minutes before start-up: 2500 rpm.
−
High speed from 2 minutes start-up to set temperature: 3200 rpm.
−
Running at low speed after reaching the set temperature: 2500 rpm.
−
When the set temperature is higher than - 12 C, the forced high speed is 3200 rpm.
−
Automatic operation mode when the setting temperature is below - 12°C.
•
When working mode is in “ECO” mode, the compressor speed is fixed to a low speed control: 2500rpm.