Geca Easy Radio, Руководство пользователя

Страница: 3 / 8

Connection to the zone valve (Fig. 10).
Fig.10
OPEN
CLOSE
230 Vac - 50 Hz
230
Va
c
NC
C
NA
ANTENNA
G H I
L M N
A B C
D E F
N.B. Before powering the unit, check that it is correctly
connected to the power supply and to the load to be controlled.
GENERAL DESCRIPTION
In order for the Easy Radio to work properly, it has to “teach” its
code to the RECEIVER . The RECEIVER , connected to the device
to be controlled (boiler, valve, pump or air conditioning system),
“learns” the code received and converts the TRANSMITTER ’s
wireless ON/OFF signal into commands for the controlled device.
The RECEIVER can also act as a BRIDGE when the distance
between the TRANSMITTER and the RECEIVER prevents the
radio signal from reaching its destination.
COUPLING THE TRANSMITTER/RECEIVER SIGNAL
F1 F2
RECEIVER
JP1 : (A-B) e (E-F)
TRANSMITTER
PROCEDURE:
Check that the unit is connected to the mains and then follow
these instructions:
1 Press and hold, for about 3 seconds, the ON button at
the back of the TRANSMITTER (Fig.11), until the RED LED
illuminates and remains steady.
2
Press, for 1 second, the teach-in button
F2
on the front of
the RECEIVER .
The GREEN LED blinks for a few moments. (The LED blinks
to indicate that coupling has been completed successfully). The
GREEN LED
on the
RECEIVER
illuminates depending on the
quality of the signal , and the
RED LED
of the
TRANSMITTER
turns off after a few seconds.
Fig.11
Led
N.B. The GREEN LED on the RECEIVER does not turn on if
coupling is unsuccessful.
At this point, repeat steps 1 and 2 of the procedure.
COUPLING OF SIGNAL BETWEEN TRANSMITTER
and BRIDGE and between BRIDGE and RECEIVER.
F1 F2
F1 F2
TRANSMITTER
BRIDGE
JP1 : (A-B) e (D-E)
RECEIVER
JP1 : (A-B) e (E-F)
A maximum of two BRIDGES can be installed between the
TRANSMITTER and the RECEIVER .
PROCEDURE:
Check that the unit is connected to the mains and then follow
these instructions:
1 Press and hold, for about 3 seconds, the ON button at
the back of the TRANSMITTER (Fig.11), until the RED LED
illuminates and remains steady.
2
Press, for about 1 second, the
F2
button on the front of the
BRIDGE
.
(The
TRANSMITTER
and the
BRIDGE
are coupled).
The RED LED on the
TRANSMITTER
remains steady for about
10 seconds.
3
When the
RED LED
on the
TRANSMITTER
turns off, press
and hold the
F1
button on the BRIDGE until the GREEN LED
illuminates.
4 Press the
F2
button on the RECEIVER .
(The
RECEIVER
and the
BRIDGE
are coupled).
The
GREEN LED
on the
BRIDGE
remains steady for 10
seconds.
N.B.
The procedure for coupling the
BRIDGE
and
RECEIVER
is the same for coupling one
BRIDGE
to another.
RESENDING THE SIGNAL
The TRANSMITTER sends the ON or OFF signal to the
RECEIVER not just once but up to three times within a period
of 5 seconds.
The transmitter then repeats this operation, sending the latest
signal to the RECEIVER every 20 minutes.
The purpose of this is to update the TRANSMITTER with
the RECEIVER/BRIDGE to ensure that the status of the
TRANSMITTER is not lost in the event of a power cut.
MANUAL LOAD FUNCTION
Press the
F1
button for 3 seconds to manually activate or
deactivate the relay of the RECEIVER.
The unit exits MANUAL mode when the TRANSMITTER sends
the first Radio signal .