19
6 SET-UP
6.1 START-UP
This section reports the operation that must be performed in order to install the equipment and some
suggestions for its start-up
6.2 EQUIPMENT INSTALLATION
Coupling to the tractor:
To couple the equipment to the tractor follow exactly the instructions below:
1.
Make sure that the equipment has been perfectly laid
fl
at and rests on the ground on the
stands, which have been suitably placed at both sides of the frame (
Fig. 05
).
2.
Back the tractor until its three points of connection will approach the equipment and verify
which of the two positions of the lower points of connections is the best one to couple your
machine.
Fig. 06
shows the coupling of two lower
narrow
"A"
points of connection and
the coupling of two lower
wide "B"
points of connection, the upper point
"C"
and the
various
heights
"D"
,
"E"
, and
"F"
for the coupling of the upper and lower pins.
3.
After having inserted both the articulated joint of the three points hitch and the check pins,
lift the machine slightly and verify if both the coupling and the lifting arms have been
correctly positioned. Check that all pins have been correctly installed and the safety devices
against set of discs sliding out have been well placed.
Fig. 06
Fig. 05
C
D
F
B
A
