8
49-85248
Electronic
ignition &
automatic
reignition
To light
a surface
burner
Dual-flame
stacked
burners
The rangetop is equipped with electronic
ignition which eliminates the need for a
standing pilot light.
The burners on this rangetop will automatically
relight if the flame goes out.
All surface burner igniters will spark and make
clicking sounds when any burner is turned on.
Do not touch any of the burners when igniters
are clicking.
Occasionally the burners may spark if excess
wind or a draft blows the flame away from the
burner’s flame sensor.
The griddle and IR (infrared) grill are equipped
with Glo-Bar igniters. The Glo-Bar remains
energized whenever the griddle or IR grill is in
use to ensure the burner always stays lit.
In case of a power outage,
you can light the
surface burners on your rangetop with a match.
Hold a lighted match to the burner, then turn
the knob to the LOW position.
Use extreme
caution when lighting burners this way.
Do not attempt to light the grill or griddle
during a power outage. The gas to these
burners will automatically shut off during a
power outage.
Push the control knob in and turn it
counterclockwise
to the
LITE
position.
WARNING
Burners should be
operated only when covered by cookware.
Burner flames not covered by cookware
present a risk of fire or clothing ignition.
Never let flames extend beyond the sides
of the cookware. Failure to comply may
result in serious injury.
After the burner ignites,
turn the knob to
adjust the flame size.
To turn a burner off,
turn the knob clockwise,
as far as it will go, to the OFF position.
Ŷ
Do not operate a burner for an extended
period of time without cookware on the
grate. The finish on the grate may chip
without cookware to absorb the heat.
Ŷ
The indicator light on each bezel verifies the
burner is on. However, it should not be a
substitute for visually checking the flame at
the burner.
All surface burners on your rangetop have two
sets of flames stacked one on top of the other;
the dual-flame burners have a lower (simmer)
flame and a upper (main) flame.
When a burner is turned on, the lower flame
will always light and stay on.
Simmering:
The stacked burner design provides a wide
rangetop of heat settings with which to
simmer. Depending on the type and quantity of
food, and pan size, the flame can be adjusted
to suit your specific need. The lowest setting
uses only the lower flame and can maintain
delicate foods at a safe 140°F.
Cooking:
Settings from
LO
to
X-HI
will use both upper
and lower flames. Use
LO
to
HI
for all purpose
cooking. Use
HI
or
X-HI
(highest setting) with
larger diameter cookware.
X-HI
and
HI
are very high heat settings and
are intended to sear foods quickly and boil
large quantities of water.
Rangetop Controls
Professional Rangetops
ON Indicator
Light
Lower
Flame
Upper Flame
Lower Flame
