10
49-80622-5
REMOVE FILTERS
Remove the protective shipping film from the edges
of the metal grease filters. Press the filter locks back and
lift the filters out. Set them aside.
REMOVE WIRING COVER
FROM THE JUNCTION BOX
Remove the wiring cover from inside the hood.
Set the cover and its mounting screw aside.
Wiring
cover
Mounting
Screw
REMOVE WIRING KNOCKOUT
Remove either the top or the back wiring knockout as
needed and install an approved strain relief clamp.
Strain relief
clamp
2
3
4
5
Filters
Installation Instructions
REMOVE DUCT KNOCKOUT(S)
If recirculating, non-vented ductless see note below and
skip to Step 7 and proceed.
Using a flat blade screwdriver, remove the appropriate
duct knockout(s) from the top or back of the hood.
3
1
ø
4
”
x 10
”
Rectangular
vertical discharge.
Remove top rectangular
duct knockout only.
3
1
ø
4
”
x 10
”
Rectangular
horizontal discharge. Remove
rear rectangular duct
knockout only.
NOTE: If the hood is to be installed in a recirculating,
non-vented ductless manner, order charcoal filters, kit
number WB02X11000 for 30
”
hood models. These kits
can be ordered from your GE supplier. Skip to Step 7C and
proceed.
NOTE: If the hood is installed for recirculation mode, it is
not E
NERGY
S
TAR
®
certified.
Содержание JVE40
Страница 30: ...14 49 80622 5 Notes ...