29
Problem
Possible Causes
What To Do
“F— and a number
You have a function
• Press the
Clear/Off
pad . Allow the oven to cool for
or letter” flash
error code.
one hour . Put the oven back into operation .
in the display
If the function
• Disconnect all power to the oven for at least 30
code repeats.
seconds and then reconnect power . If the function
error code repeats, call for service .
Display goes blank
A fuse in your home may
• Replace the fuse or reset the circuit breaker .
be blown or the circuit
breaker tripped.
The clock is in the
• See the
Special features of your oven control
section .
black-out mode.
Display flashes
Power failure.
• Reset the clock .
Unable to get the
Oven control pads were
• The
Bake
and
Broil Hi/Lo
pads must be pressed
display to show “SF”
not pressed properly.
at the same time and held for 3 seconds .
Power outage,
Power outage or surge
.
• Reset the clock . If the oven was in use, you must reset
clock flashes
it by pressing the
Clear/Off
pad, setting the clock
and resetting any cooking function .
“Burning” or “oily”
This is normal in a
• To speed the process, set a self-clean cycle for a
odor emitting from
new oven and will
minimum of 3 hours . See the
Using the self-cleaning
the vent
disappear in time.
oven
section .
Strong odor
An odor from the insulation
• This is temporary .
around the inside of the
oven is normal for the first
few times the oven is used.
Fan noise
A cooling fan may
• This is normal . The cooling fan will turn on
automatically turn on.
to cool internal parts . It may run for up to 1-1/2
hours in 30” models and up to 2 hours in 27” models
after the oven is turned off .
GEAppliances.com