47
09665
-0
8.
20
18-
Gb
8
Install of the oil pump
Position in
parts list
Parts list position: 2020
Tools: Spanner SW 13
Working course
40, 41
460, 470
- The sealing surfaces have to be clean. Slightly oil seals
- Install the oil pump with gasket into the body with the inscription „TOP“ facing upwards!
- Screw oil pump tightly. Tighten the screws (M8x30) crosswise
12 I Assembly of compressor
34 Nm
INFO
Adjust axial clearance!
The axial clearance of the crankshaft must be at least 0.15 mm. When parts of the driving unit of the
compressor have been repaired or replaced, an accurate measurement of the axial clearance is neces-
sary. The measurement has to be at the disassembly shaft seal cover. If the axial clearance is less than
0.15 mm, the bearing flange must be disassembled and a second seal must inserted.
second seal
INFO
Pay attention to the position of the holes in the gasket!
1
2
3
INFO
Observe the tightening torques!
Pay attention to the tightening sequence of the screws!
1
4
6
8
2
3
5
7
