– 8 –
Components
Troubleshooting
If ice cubes get stuck in the icemaker, the green
power light will blink. To correct this, set the
icemaker power switch to
O
(off) and remove the
cubes. Set the icemaker power switch to I (on) to
restart the icemaker. After the icemaker has been
turned on again, there will be a delay of about 45
minutes before the icemaker resumes operations.
Note:
In homes with lower-than-average water
pressure, the icemaker may cycle multiple times
when making one batch of ice.
Icemaker
Feeler Arm
Power Switch
Green
Power Light
Icemaker
The icemaker will produce seven cubes per
cycle - approximately 100 to 130 cubes per day
(approximately 4.8 lbs). Ice rate is dependant
on freezer compartment temperature, room
temperature, number of door openings, and other
use conditions.
The icemaker will fi ll with water when it cools to
15°F (-10°C).
A newly installed refrigerator
may take 12 to 24 hours to begin making ice
cubes.
The icemaker will make a buzzing sound each
time it fi lls with water. Be sure nothing interferes
with the sweep of the feeler arm.
Tab (push tab down on
right drawer guide, pull
tab up on left drawer
guide)
Full Extension Drawer
To remove the full extension drawer, pull the
drawer out to the STOP position. Push the tab on
the right rack guide down while pulling the tab on
the left rack guide up, and pull the drawer out.
To replace the full extension drawer, insert the
sides of the drawer back into the guides and
push until the tabs snap into place. Make certain
the tabs on the drawer are fully engaged before
loading. Pull the drawer out all the way to the
STOP position and push back in several times to
make sure locking tabs are properly engaged.
Interior Lights
Run diagnostic mode
22
and
21
to test the light
circuit and reed switches. (
See
Diagnostics and
Service Information
.)
A single 15-watt lamp recessed in the back wall of
the fresh food compartment provides light to the
interior. The light is activated by 1 magnetically
operated reed switch located on the logic board.
The reed switch is not serviceable.
Note:
The door reed switch magnet is part of the
door and is not serviceable.
