GE Voluson E8, Руководство по обслуживанию

Страница: 341 / 432

GE H
EALTHCARE
DRAFT V
OLUSON
E8 / V
OLUSON
E6
D
IRECTION
KTD102576, R
EVISION
7 DRAFT (A
UGUST
23, 2012) S
ERVICE
M
ANUAL
Chapter 8 - Replacement Procedures 8-23
Section 8-15
Replacement of the Caps for Hardkeys
NOTE: The FRU part depends on Console (RTU).
Console version (
R afi or W hanam) is shown in the System Info page (see: Figure 7-1 on page 7-3 ).
8-15-1 Replacement of Circle Key Caps only
NOTE: The FRU part depends on Console (RTU).
Console version (
R afi or W hanam) is shown in the System Info page (see: Figure 7-1 on page 7-3 ).
8-15-1-1 Manpower
One person, approx. 1 minute/cap
8-15-1-2 Tools
small-sized slotted screwdriver or tweezers
8-15-1-3 Circle Key Caps - Replacement Procedure
1.) By means of a small slotted screwdriver, carefully push against the circle hardkey cap.
2.) Lift the cap, until it is completely loosened from its base.
3.) Place the new hardkey cap down until it snaps into position.
NOTICE
!! NOTICE:
Replacement procedure depends on key caps that have to be replaced!
• if just the circle key caps have to be replaced, refer to: Section 8-15-1 on page 8-23
• if trackball buttons or mode key slices have to be replaced too, please contact your local distributor
or GE service representative.
Figure 8-25 push against the circle cap and lift it