31-1000385 Rev. 0
3
4
REMOVE EXISTING DRAIN TUBE
Remove the existing drain tube. The drain tube
is the white tube with a white snap fit clamp on it
in the upper left hand corner of the side service
panel access area. Save the snap fit clamp. It
will be used to install the new drain tube.
5
INSTALL THE PUMP KIT
A. Uncoil the 10-foot long discharge tubing
(clear). Push one end completely onto the
barbed discharge elbow of the pump and
securely fasten it with the small metal hose
clamp. Use pliers to open the hose clamp.
B. Route the other end of the discharge tubing
through the routing panel in the back of the
unit. Put the end of the discharge tube into a
drain.
5
INSTALL THE PUMP KIT (Cont.)
C. Place the pump over the bolts located on the
base of the ice machine and secure with the
two nuts and washers provided in the kit.
D. Route the straight portion of drain tube
through the hole in switch assembly bracket.
E. Connect drain tube to pump inlet and secure
with the white snap fit clamp from the kit.
F. Connect the pressure switch hose to the
drain tube.
G. Mount the switch assembly bracket to the
base using two provided sheet metal screws
and lock washers.
Existing Drain Tube
Snap Fit Clamp
Installation Instructions
Bolts
Nut & Washer
Pump drain
discharge tubing
Side view of unit.
Drain tube
Snap fit
clamp
Switch
assembly
bracket
Pump
inlet
Pressure
switch hose
Drain tube
Switch
assembly
bracket
Sheet metal
screws & lock
washers
Side View of Unit
Discharge tubing
Side of the unit
Discharge
tubing
Discharge
elbow
Hose clamp
INSTALLING PUMP KIT
(Continued)
