GE Transport PT878, Краткое руководство

Страница: 25 / 97

August 2008
2-2 Initial Setup
Entering the Program
Menu (cont.)
When entering information in an option window, press:
•
the [
T
] key to scroll down the list
•
the [
S
] key to scroll up the list
•
the
[F2]
key (Cancel) or the
[ESC]
key to close a window at any time
and return to Operate Mode without changing the data.
Note: If you enter an incorrect numeric value, press the [
W
] key to
erase the last digit entered.
Entering the Transducer
Parameters
To program the Transducer data, scroll to the Transducer option on
the Program Menu and press [ENTER] (see Figure 2-2 below).
Note: Refer to your Transducer Installation Guide for additional
information about transducers and configurations.
.
Figure 2-2: The Transducer Option Window
1.
At the Type prompt, use the [
W
] and [
X
] keys to select the type of
transducer used in your installation ( wetted or clamp-on ). Press
[ENTER] to confirm the choice.
Note: Each choice made in the Transducer and Pipe menus will
determine the additional options that must be programmed.
Transducer
Pipe Lining
Path
Transducer/Pipe
OK
Cancel
Fluid
Type: Wetted
Clamp-on
Transducer Special
Frequency 2.00 Tw
14
MHz
Wedge Ang
50
°
Wedge Tmp 25 °C
Wedge SS
1219.2
m/s
µs