Before Using Your Icemaker and Dispenser
If you use your refrigerator before
the water connection is made, raise
the ice access door and
sure
the icemaker feeler arm is in the
STOP (up) position.
arm in
m
in
(up)
n)
position
position
When water supply has been connected to
move feeler arm to ON (down) position.
Depress water dispenser cradle for about two minutes
to remove trapped air from the water line and to fill
water reservoir automatically.
Ice cube mold automatically fills with water after
cooling to freezing temperatures. First cubes
freeze after several hours.
NOTE: With a newly-installed refrigerator, allow
about 24 hours for the freezer compartment to cool
down to the proper
temperature.
Once Your Icemaker and Dispenser are in Operation
Throw away the first few batches of ice cubes (16 or
24 cubes). This will flush away any impurities in the
water line. Do the same thing after vacations or
extended periods when ice isn’t used.
Discard
six
of water in the
sink. This will eliminate the slight “plastic” taste
—
temporarily imparted to the water by the water reservoir.
Keep ice level to keep icemaker productive.
Cubes
ejected into an empty storage bin will pileup close to
the
and push the feeler arm up to the STOP
position prematurely when the bin is only partially full.
the ice access door, reach in, level the cubes by
hand and
will resume. Keeping cubes
distributed evenly will allow the
to produce
enough ice to fill the bin to its maximum capacity.
circumstances,
maybe
usually
a green-bluish
The cause
discoloration is
due a combination of factors such as
of local waters, household
accumulation of copper salts an
water supply
which feeds the
Continued consumption of such discolored
be injurious to
such discoloration is
the
cubes and contact your
Factory
or an
Customer
Care
@
Servicer,
To Dispense Ice and Water
(on models
one cradle)
●
Set selector switch to CUBES, CRUSHED
ICE or WATER.
Grip glass or other container near the rim and press
rim gently but
against the rubber-cushioned
cradle.
To Dispense Ice and Water
(on models with two cradles)
●
For ice, set selector switch to CUBES or
CRUSHED. For water, simply position glass
beneath the word “WATER.”
●
Grip glass or other container gently near the rim and
press rim firmly against ice or water dispenser cradle.
(continued next page)
5
