1997 REFRIGERATORS
GLOBAL NEW GENERATION
SxS
© General Electric Company 1997
18
Lamp Socket
To remove the lamp socket -- first
remove the control housing. Then,
disconnect the wiring harness from the
lamp socket. Compress the tabs at the
sides of the socket and withdraw the
socket and lamp reflector from the
bottom of the control housing.
To reinstall the lamp socket --
position it inside the reflector,
aligning the ribs and tabs with the
slots in the reflector. Then,
position the socket and reflector into
the cavity in the control housing and
press the socket firmly to lock the
tabs. Reinstall the wiring harness,
control housing, escutcheon, pad
support and pad.
Pad Switch
To remove the pad switch -- first
remove the control housing. Then,
disconnect the wiring harness from the
switch. Remove the screw at the
bottom of the switch and slide the
switch off of the the mounting pin.
To reinstall the pad switch --
position it on the mounting pin so
that the terminals are at the top and
the switch lever is toward the rear,
but in front of the actuator paddle.
Then, reinstall the screw at the
bottom of the switch and reconnect the
wiring harness. Caution: check the
position of the switch lever to verify
that it is in front of the actuator
paddle by rotating the actuator and
observing the operation of the switch.
Reinstall the control housing,
escutcheon, pad support and pad.
