Power
supply
To Tetra Contour LS
Red (+)
Black or blue (-)
1
2
Run a wire from the power supply to
a section of Tetra Contour LS.
NOTE:
Power supply connection
must be contained in an acceptable
UL/NEMA enclosure.
Cut off the quick connector on
the Tetra Contour LS that you are
connecting to the power supply.
Weather box can be painted
4
Insert wire connectors into weather
box. Fill with electrical grade silicone
and close box.
5
Secure the weather box using a
#6 or #8 (M2 or M3) screw.
NOTE:
When using twist-on
connectors, weather box is required
for all outdoor electrical connections.
Must be used with Tetra 24 Volt Power Supplies. Refer to the Power Supply Installation Instructions for more information on the power supply.
Electrical Connections
WARNING
Risk of electrical shock. Turn power OFF
before inspection, installation or removal.
3
Using twist-on wire connectors,
connect the white wire with red
stripe (+) from the LED strip to the
red wire (+) of the power supply.
Connect the white wire (-) from the
LED strip to the black or blue wire (-)
of the power supply.
NOTE: Grounding and bonding
must be done in accordance with
National Electrical Code (Article 600).
See power supply instructions.
White with
red stripe (+)
Red (+)
White (-)
Black or
blue (-)
To power supply
Tetra Contour LS
+
+
+ –
–
Tetra Contour
White wire with
red stripe
Tetra Contour LS
Tetra Contour
Outside wires (+)
Center wire (-)
White wire with red stripe (+)
White wire (-)
Optional
–Attaching Tetra Contour LS to Tetra Contour
2
Splice the white wire with red stripe (+) of Tetra Contour LS
to the two outside wires (+) of Tetra Contour and splice the
white wire (-) of Tetra Contour LS to the center wire (-) of
Tetra Contour.
NOTE: Weather box is required for all outdoor
electrical connections.
1
When connecting Tetra Contour LS to Tetra Contour,
separate wires and identify conductors as positive (+)
and negative (–). Strip ends back 0.5 in. (12mm).
