GE T2100, Руководство по обслуживанию

Страница: 112 / 152

7-10 GE T2100 Treadmill Revision A
2021403-031
Assembly/Disassembly: Walking Belt and Board Replacement
5. On the front right side of the GE T2100 Treadmill, remove the eight,
1/2-inch bolts that hold the frame’s sliding bracket in place.
6. Slide the bracket left, into the frame.
NOTE
Don’t worry if the bracket slides in too far. During re-assembly
you can lift the back end of the GE T2100 Treadmill and the
bracket will slide back where you can reach it.
7. Slide the belt between the rear and front roller, removing the belt
from the rear roller first.
8. Replace the walking board before re-installing a new walking belt.
See “Walking Board Replacement Instructions” on page 7-10.
NOTE
The wax material on the walking board acts as a lubricant for the
belt. We recommend that you replace the walking board every
time you put on a new walking belt to ensure the belt absorbs the
required amount of lubricant.
Walking Board Replacement Instructions
1. Remove the walking belt as instructed in the previous steps.
2. Remove the eight, 5/32-inch Allen-head, counter-sunk screws from
the top of the walking board. (The fastening nuts on the underside of
the GE T2100 Treadmill are welded in place.)
3. Lift the walking board off the GE T2100 Treadmill.
Sliding Bracket
Bolts, 8 Places
Sliding Bracket
032