GE T2100-ST1, Руководство оператора

Страница: 13 / 50

Introduction
2097937-001 Rev E T2100-ST1 Treadmill, 110V / T2100-ST2 Treadmill, 220V 13
12 June 2017

Read this Operator’s Manual before operating the T2100-ST
Series Treadmill .

Assist in off-loading the patient in the event of abnormal or
unexpected operation of the treadmill.

If the treadmill is not responding properly, stop the treadmill,
assist in removing the patient off the running belt, unplug the
treadmill power supply, and seek factory authorized repair
before attempting to restart the treadmill.

Never allow children or pets near the machine without qualified
adult supervision.

Note the location of stop and/or emergency stop controls and
their operation before starting a test or workout.

This device is not intended for use by persons with reduced
physical, sensory or mental capabilities, or lack of experience
and knowledge unless they have been given supervision or
instruction concerning use of the appliance by a person
responsible for their safety.

Verify the Patient and Operator both know how to stop the
machine in the event of malfunction or emergency.

Patient should not wear loose fitting nylon material when
exercising on this treadmill to avoid generating Electro Static
Discharge.

Never attempt to remove any article of clothing while the
running belt is moving.

All persons on and around the treadmill must wear enclosed,
protective footwear. Shoe laces must be tight and not drape as
to cause a trip or catch hazard. Sandals, flip flops, slippers and
the like are not considered enclosed, protective footwear.

Walk in the center of the running belt. Contact with the side rail
and the moving belt could cause injury.

The Patient must always wear the Stop Tether lanyard wrist
strap while operating the
T2100-ST Series Treadmill

Place the treadmill on a hard, level and unobstructed surface.
See Chapter 3
“ Assembly and Setup “ of this manual.

Check input power cord connection and location for hazardous
pinch points before use.

Check input communications cord connection (if equipped) for
proper interface with all equipment.

Keep all cords clear of patient to avoid trip hazards.