Special
Instruction
Save and refer to Garment
Instructions
Permanent Press
Do not overload dryer; clothes should tumble freely. Remove as soon as dryer
stops; place clothes on hangers to minimize
Polyester Knits
Do not overload dryer; clothes should tumble freely. Remove as soon as dryer
stops; place clothes on hangers to minimize
Baby Clothes–Sturdy:
Important: If children’s
is made of
dry only on Low
Diapers, Nightgowns,
Heat/Timed Cycle or Delicate Cycle. High Heat or excessive drying can reduce
Pads, Sheets, Receiving
the flame
of these fabrics. Check manufacturer’s drying instructions.
Blankets, Coveralls.
I
Baby Clothes—Delicate
See above instructions.
Blankets—Wool, Part Wool,
Follow manufacturer’s instructions. Do only one blanket at a time. Partially dry
Cotton
in your dryer for no longer than 20 minutes. Remove while still damp and finish
drying on flat surface.
Plastics—Aprons, bibs,
Use Fluff (No Heat)
tablecloths, chair covers,
bowl covers, curtains.
Care and
USER
●
To
keep your dryer looking
good,
cabinet with a damp
cloth. Occasionally wash it with
mild soap and water and then apply
a light coat of appliance polish to
help preserve the finish.
●
Clean the lint falter before every
load. See page 6.
. Keep area around and underneath
your appliance free from the
accumulation of combustible
materials, such as lint, paper,
rags, chemicals, etc.
●
Keep the floor around your
appliances clean and dry to reduce
the possibility of slipping.
●
Do not store dryer where it will
be exposed to the weather.
●
If your dryer is exhausted to the
inspect and clean dryer
exhaust
at least once a year.
How to
reduce the possibility
of a fire hazard,
if your dryer is
not exhausted to the outside:
A clothes dryer produces
combustible lint. When the dryer
is not exhausted to the outside, this
lint is more apt to accumulate in
and near the dryer, which could
create a fire hazard.
It is imperative to keep the laundry
area (around the washer and dryer)
and free from the accumulation
of lint, paper, rags, etc. Clean this
area regularly.
Also inspect the dryer’s blower
compartment at least once a year
and remove accumulated lint as
Blower Compartment Access
.
follows:
With
unplugged, remove two
1. Unplug the dryer.
at bottom of
blower
access panel.
2. Remove the access panel.
bottom
out until clips
3. Clean out any lint that may have
slip out. To replace, slip top of
accumulated. Wipe or vacuum,
panel up until clips are secured.
being careful not to disturb any
Press bottom
in and
replace
electrical or mechanical connections.
8
