GE Simon XT Quick User Guide
Page 2
Arming & Disarming the System
Arming (Turning on)
Close all sensors (i.e. close doors and windows). The ready indicator should be on. Arm the system
using either of the methods below.
Arming Method – Stay Mode
Press DOORS+WINDOWS button. Panel will then display and/or say “Doors and Windows On” and
the DOORS+WINDOWS button lights up. The arming process begins with exit beeps sounding.
Arming Method – Away Mode
Press the MOTIONS button. Panel will then display and/or say “Motions On, Doors and Windows On,
Motions On” and the DOORS+WINDOWS button and MOTIONS button will light up. The arming
process begins with exit beeps sounding.
Disarming – Off
Press DISARM, the display shows “ENTER CODE”, then enter your code. The panel will then display
or say “Disarmed” and the DISARM button will light up.
Silent Button
– Press to silence exit beeps when arming.
Bypassing Zones
Use the zone bypassing feature when you want to arm the system, but skip a zone that you want to
leave open or requires service. Bypassed zones will not sound an alarm.
Bypassing:
1. After arming the system in the manor you wish, press the BYPASS button and enter the
MASTER CODE.
2. Scroll up/down to find the sensor you wish to bypass. Press OK to bypass.
3. When the sensor is bypassed, the panel display will show “Bypassed”.
Unbypassing:
1. Press BYPASS and enter the MASTER CODE.
2. Scroll up/down to find the sensor you wish to put back in service.
3. Press OK and the display will no longer show the word “Bypassed”.
Before Calling…
♦
Is the keypad beeping? Press STATUS. This will silence the beeping and
let you know where the trouble is.
♦
Is there a flashing * on the keypad? Press the STATUS button to find out
trouble.
♦
Is the siren going off? Press DISARM and ENTER CODE to stop siren.
