Installation Instructions
1 Ft = 0.3 m
1” = 2.5 cm
8
TOOLS AND MATERIALS REQUIRED
(NOT SUPPLIED)
Duct Tape
¼” Pivoting Hex Socket
Pencil and
Tape Measure
Spirit Level
Phillips and
Flat Blade Screwdrivers
Electric Drill with
1/8” and 3/8” Bits
cUL Listed Wire Nuts
Hammer
Safety Glasses
Metal Snips
Flashlight
Pliers
Wire Cutter/Stripper
Saber Saw or Key Hole Saw
Ladder
Allen Wrench
• 4 #10 pan head wood screws for installation on the
bottom of a cabinet.
CAUTION!
Lamps are not supplied; use ONLY
120 Volt, 50 Watt (maximum) 50° halogen light made for
a GU10 base, suitable for use in open luminaries.
Additional Materials:
• 120V 60Hz. 15 or 20 Amp, 2-wire with ground,
properly grounded branch circuit.
• Strain relief for junction box.
• ½” conduit.
• Round or rectangular duct.
• Round backdraft damper.
PARTS PROVIDED
• Hood canopy assembly with blower already installed
• Grease filters
• Drip trays
• Care & Use/Installation Instructions
• Fittings bag with:
2 Drip trays holding br plastic washers and knobs
4 Washers
6 Drywall anchors
2 Hooks with regulating screws
6 Screws 5 x 35
4 Screws 4 x 8 for transition
1 Transition
INSTALLING THE HOOD
• For the most efficient air flow exhaust, use a straight
run or as few elbows as possible.
CAUTION!
Vent unit to outside of building only.
• One person is necessary for installation.
On average 2 hours are necessary to complete
installation (not including cut to be made in wall
and/or cabinet, installation of ducts, conduit and
electrical connections to the mains).
Installation steps:
12 installation steps are required for both installation
methods: wall mount or in alternative cabinet installation
• The hood is fitted with screws and drywall anchors
suitable for most surfaces. Consult a qualified installer
to check if they perfectly fit with your cabinet/wall.
• Do not use flex ducting.
• COLD WEATHER installations should have an
additional backdraft damper installed to minimize
backward cold air flow and a non metallic thermal
break to minimize conduction of outside temperatures
as part of the ductwork. The damper should be on the
cold air side of the thermal break.
The break should be as close as possible to where the
ducting enters the heated portion of the house.
• Make up air: local building codes may require the use of
make-Up air systems when using ducted ventilation
systems greater than specified CFM of air movement. The
specified CFM varies from locale to locale. Consult your
HVAC professional for specific requirements in your area.
OPTIONAL ACCESSORIES
Ductless Recirculation Kit:
• KITRIALTO 30”: PVUS830
• KITRIALTO 36”: PVUS836