6
31-7000092 Rev. 3
TOOLS YOU WILL NEED
#1 and #2
Phillips
screwdriver
Pencil
Ruler or tape measure and
straight edge
Carpenter square
(optional)
Tin snips (for cutting
damper, if required)
Electric drill with
3
»
16
Ǝ
7
»
16
Ǝ
1
»
2
ƎDQG
5
»
8
ƎGULOOELWV
Hammer (optional)
Stud
finder
Filler blocks or scrap
wood pieces, if needed
for top cabinet spacing
(used on recessed
bottom cabinet
installations only)
Gloves
Saw (saber, hole or keyhole)
Level
Duct and masking
tape
Scissors (to cut
template, if necessary)
Safety goggles
MOUNTING SPACE
•
7KHVSDFHEHWZHHQWKHFDELQHWVPXVWEHƎZLGH
and free of obstructions.
•
This oven is for installation over ranges up to
ƎZLGH
•
If the space between the cabinets is greater than 30”,
a Filler Panel Kit may be used to fill in the gap between
the microwave oven and the cabinets. Your Owner’s
Manual contains the kit number for your model.
•
If you are going to vent your oven to the outside, see
Hood Exhaust Section for exhaust duct preparation.
•
When installing the oven beneath smooth, flat
cabinets, be careful to follow the instructions on the
top cabinet template for power cord clearance.
• * 13” max: for standard installation, 15” cabinet
depth requires additional steps using an additional
installation kit JX15BUMPWW/BB.
• For models with top venting holes: Do not allow
cabinetry or other objects to block the airflow of the vent.
• This microwave is suitable for installation over electric or
gas cooking appliances with a combined BTU of 63,000
BTU or less.
• Café branded gas cooking appliances should only be
installed in combination with a Café branded over-the-
range microwave.
• Monogram branded gas cooking appliances should only
be installed in combination with a Monogram branded
over-the-range microwave.
• Monogram branded gas cooking appliances with a
combined BTU greater than 66,000 BTU should not be
paired with an over-the-range microwave.
Backsplash
ƎRUPRUH
from the floor
to the top of
the oven
Ǝ
2
Ǝ
Ǝ
min.
16-
1
»
2
Ǝ
Bottom edge of
cabinet needs
WREHƎRU
more from the
cooking surface
ƎPD[
Installation Instructions
