31-7000092 Rev. 3
13
AFTER: Fan Blade
Openings Facing
Forward
3
2
4
ADAPTING BLOWER
FOR RECIRCULATION
A4.
NOTE:
The exhaust adaptor with damper is not
needed for recirculating models. You may want to
save them for possible future use.
Roll the blower unit 90° so that fan blade openings
are facing toward the front of the oven.
Roll
Slide the blower plate from under its retaining
flange and lift it off. Remove the cover plate
installed on the back. Remove and save screws
that hold blower unit to the oven.
Remove and save screws that hold blower plate
to the oven.
BEFORE: Fan Blade
Openings Facing Up
1
Blower Plate
Back of
Oven
Cover Plate
Blower Plate Screws
CHECK BLOWER MOTOR
ORIENTATION
The blower fan blade opening should be facing the
front of the microwave. You will have to remove the
top cover plate to check the fan blade orientation.
If the fan opening is already facing the front of the
microwave, skip to step A5. Otherwise, continue to
Step A4 to adjust the fan motor orientation.
A3.
Blower
Plate
Retaining
Flange
Blower Motor
Screws
Cover Plate
Carefully pull out the blower unit. The wires
will extend far enough to allow you to adjust the
blower unit.
Installation Instructions
