– 8 –
Enhancements
The light above the selected pad will be
ON
to indicate which
ENHANCEMENT
has been selected.
DELAY HOURS
You can delay the start of a wash cycle for up to 24 hours (depending on model). Press the
DELAY START
pad to choose the number of hours you want to delay the start of the cycle; then
press
START/RESET.
After closing the door, the machine will count down and automatically start at the correct time.
NOTE:
To cancel the
DELAY START
selection before the cycle begins, press the
DELAY START
pad until the display shows the estimated cycle time for the selected cycle in minutes.
4
ADDED HEAT
When selected, the cycle will run longer with heating element on to improve both wash and dry
(EXTRA HOT WASH)
performance.
NOTE:
Cannot be selected with
RINSE ONLY
cycle.
PRE WASH
For use with heavily soiled and/or dried-on, baked-on soils. This option
MUST
be selected
PRIOR
to
(on some models) starting the cycle. This option adds 15 minutes to the cycle time.
NOTE:
Cannot be selected with
RINSE ONLY
cycle.
HEATED DRY
Shuts off the drying heat option. Dishes will air dry naturally (PDW8900 Series) or
Light Off fan dry (PDW9700 and PDW9900 Series) to save energy.
HEATED DRY
Turns the heating element on for fast drying. This will extend the total cycle time by 15 minutes for
the
ANTI-BACTERIAL
cycle, 8 minutes for the
SPEED
cycle, 15 minutes for the
PLASTICS
cycle,
30 minutes for the
CHINA CRYSTAL
cycle, and 38 minutes for all other cycles.
NOTE:
Cannot be selected with
RINSE ONLY
cycle.
LOCK
You can lock the controls to prevent any selections from being made. Or you can lock the controls
after you have started a cycle.
Children cannot accidentally start dishwasher by touching pads with this option selected.
To unlock the dishwasher controls, press and hold the
HEATED DRY
pad for 3 seconds. To lock the
dishwasher, press and hold the
HEATED DRY
pad for 3 seconds. The light above the
LOCK
pad
will turn off.
RESET
To change a cycle after washing starts…
PDW8900 Series:
Touch the
START/RESET
pad to cancel the cycle. The
START/RESET
light will
flash while the water is pumped out if needed. This takes approximately 2 minutes.
PDW9700 and PDW9900 Series:
Open the door slowly to prevent splash-out. Touch the
START/RESET
pad to cancel the cycle. If the
START/RESET
light is flashing, close the door
until the water pumps out (this takes approximately 2 minutes) and the light stops flashing.
When the light stops flashing, the dishwasher can be reprogrammed and restarted.
