– 46 –
Door Latch Assembly
The door latch assembly consists of a lock motor
cam and switch assembly, lock hook, and
mounting plate. It is located under the lower heat
shield of the maintop burner assembly.
The lock motor is energized when the control is
set for CLEAN and CLEAN TIME is selected.
The K4 relay contacts will close and complete the
circuit that supplies the voltage to the lock motor.
Thermal Switches
The thermal switches are located on the floor of
the component compartment in front of the fan
motor and protect the electronics from damage
should a high temperature condition occur. The All
Gas Range has a single thermal switch. The Dual
Fuel Range has an additional bake thermal switch
located on the oven vent tube.
•
Oven Temperature Above 600°F (315°C). Any
mode of operation control will go to -F2- failure
code. When this condition exists, check the
fan operation (look for obstructions), inspect
oven installation (make sure grill areas are not
blocked), oven insulation and lock circuit.
Bake Thermal Switch
The bake thermal switch is wired in series with
the lock motor switches. The bake thermal switch
opens at 169°F (76°C) and closes at 140°F
(60°C). If the bake thermal switch opens during
Bake, the program is cancelled and the lock
motor will run. The words LOCK DOOR will flash
in the display.
To remove the thermal switches:
1. Remove the maintop burner assembly (see
Maintop Burner Assembly).
2. Remove the upper and lower heat shield (see
Upper and Lower Heat Shield).
3. Note the placement of the wiring to the
thermal switch that is being removed.
Disconnect the wiring.
4. Remove the 2 hex-head screws that hold the
thermal switch in place.
5. Remove the thermal switch.
All Gas Range
Thermal Switch
Dual Fuel Range
Bake Thermal Switch
Thermal Switch
Thermal Switch
The thermal switches for both ranges are wired in
series with the lock motor switches. The thermal
switch opens at 275°F (135°C) for the All Gas
Range and 240°F (115°C) for the Dual Fuel
Range. The switches close when temperatures
cool below 190°F (88°C). If the thermal switch
opens during:
•
Oven Temperature Below 600°F (315°C).
Program is cancelled when thermal switch
opens. Lock motor will run and the words
LOCK and DOOR will be flashing in the
display.
Содержание Profile J2S968 SERIES
