GE PGP989, Инструкция по эксплуатации

Страница: 1 / 8

Questions? Call 800.GE.CARES (800.432.2737)
or
Visit our Website at:
ge.com
High Altitude Gas Cooktop
Instructions
Read these instructions completely and carefully.
•
IMPORTANT –
Save these
instructions for local inspector’s use.
•
IMPORTANT –
Observe all
governing codes and ordinances.
•
Note to Installer –
Be sure to leave these
instructions with the Consumer.
•
Note to Consumer –
Keep these
instructions for future reference.
BEFORE YOU BEGIN
• This cooktop is factory set for natural gas operation.
Conversion to high altitude operation should be
performed by a qualified technician or installer. Keep
these instructions for future reference. When converting
to high altitude, save the original parts for possible
future use.
Use the following kit depending on the type of gas
the cooktop is set for:
Natural Gas High Altitude Conversion Kit ........WB28X10114
LP Gas High Altitude Conversion Kit...................WB28X10115
• Product failure due to improper installation is not
covered under the GE Appliance Warranty.
PGP989
WARNING –
This conversion kit shall be
installed by a qualified service agency in accordance
with the manufacturer’s instructions and all applicable
codes and requirements of the authority having
jurisdiction. If the information in these instructions
is not followed exactly, a fire, explosion or production of
carbon monoxide may result, causing property damage,
personal injury or loss of life. The qualified service agency
is responsible for the proper installation of this kit. The
installation is not proper and complete until the operation
of the converted appliance is checked as specified in the
manufacturer’s instructions supplied with the kit.
CAUTION –
Before proceeding with the
conversion, shut off gas supply to the appliance prior
to disconnecting the electrical power.
FOR YOUR SAFETY:
1
Adjustable wrench 9/32
″
(7 mm) Nutdriver
TOOLS YOU WILL NEED
T15 Torx driver
PART QUANTITY
Brass orifices 4
Stick-on rating label 1
Installation instructions 1
PARTS INCLUDED WITH KIT
Small, thin-blade flat screwdriver with approximately 1/8
″
blade width is needed to access the calibration screw.
49-80561
08-08 JR
Printed in the United States