3
Set touchpad number and partition (94)
To set the touchpad number and partition, do the following:
1.
Enter
* 94
.
2.
Enter your program code.
3.
Enter the touchpad number (see
Table 2
) and press
*
.
4.
Enter the partition number and press
*.
5.
To exit, press #.
Add transmitters
To add transmitters to the touchpad receiver, do the following:
1.
Enter
* 8
at the touchpad.
2.
Enter your program code (factory default is 9 7 1 3).
3.
Enter the device number (
Table 2
) and press
#.
4.
To load factory defaults and clear unwanted information in
memory for new installations, enter
9 1 0 #
.
5.
To determine the starting zone number for the specific
touchpad receiver on new installations, set the receiver zone
bank (Location 594) The bank setting is based on the zone
capabilities of both the receiver and the panel and must be
set before you add (learn) transmitters.
6.
Enter
400 #
to enter the sensor (transmitter) learning location.
7.
Enter a zone number
(
1 to 192) and press
*
. Three beeps
from the touchpad indicates an entry error. This occurs if
you enter a transmitter number that is not within the
receiver’s zone block or if you try to learn a transmitter that
is already learned into the receiver.
Note:
If you change your mind about your entry, enter
400
# 0*
to terminate programming and start over from
step 6.
8.
Trip the desired transmitter (within 250 seconds) as described
in
Table 3
. Listen for the
ding dong
for confirmation.
9.
To program remaining transmitters, repeat steps 6 to 8.
10. To exit program mode, press
EXIT EXIT
.
Table 2.
Device numbers
Partition
Touchpad
1
2
3
4
5
6
7
8
1
192
193
194
195
196
197
198
199
2
200
201
202
203
204
205
206
207
3
208
209
210
211
212
213
214
215
4
216
217
218
219
220
221
222
223
5
224
225
226
227
228
229
230
231
6
232
233
234
235
236
237
238
239
7
240
241
242
243
244
245
246
247
8
248
249
250
251
252
253
254
255
Table 3.
Tripping transmitters
Transmitter
Action
Door/window, shock, glass
guard, freeze, UFT
Activate tamper switch by removing cover.
Door/window with external
contact
Activate tamper switch by removing cover.
Feature 4—Input option 1, must be on.
Recessed door/window
Activate tamper switch by removing circuit
board until tamper switch is exposed.
Micro door/window and
Micro recessed door/window
Refer to the installation instructions for the
specific sensor for activation information.
SlimLine door/window
Remove cover, then press the button on
the top of the sensor, or activate the
tamper switch by removing the cover.
PIR
Refer to the installation instructions for the
specific sensor for activation information.
Smoke detector without
tamper switch
Press and hold the test button.
Smoke detector with tamper
switch
Trip the tamper switch.
Feature 4—Input
option 1, must be on.
Heat detector
Press, then release the tamper switch.
Single button panic
Press and hold the button.
Dual button panic
Press and hold both buttons together.
Keyfobs
Press and hold the arm and disarm
buttons together.
Repeater
Press, then release the tamper switch.
