NX-148E LCD Code Pad Installation and Setup Manual
18
8. Multi Area Systems Operation
8a. Master Mode
The LCD code pad can be programmed to operate all system areas simultaneously. To set the multi-area
mode, use the
function as described on page 10, and answer ‘Yes’ to the question ‘Master code
pad?’
8b. ‘Temporary’ Master Mode
Press
[user code]
to temporarily access the master mode. The code pad will revert back to its
assigned area 60 seconds after a key press or 10 seconds without a key press. Press
#
to exit.
8c. Lights in Multi Area Master Mode
#
Armed will illuminate if all areas are armed.
#
Ready will illuminate if all areas are ‘Ready’. The ready light will flash if all areas are Ready
or Force armable.
#
Fire will illuminate if any one area has a Fire condition. The fire light will flash if any area has
a Fire Trouble condition.
#
Power will illuminate if the primary power is connected to the NX control panel. It will flash if
the system has a low standby battery condition.
#
On will illuminate if any area is fully armed.
#
Chime will illuminate if any area is in the ‘Chime’ mode.
#
Exit will illuminate if any area is timing an exit delay. It will flash if any area is in the last 10
seconds of an exit delay.
#
Bypass will illuminate if any area has a zone bypassed.
#
Sounder will sound if any area has the sounder on. This includes Entry delay, Exit delay,
Chime, and Alarm.
#
Partial will illuminate if any area is partially armed.
8d. Displays In The Multi Area Master Mode
Armed and Ready Status
The LCD screen will display the Armed and Ready status of all eight (8) areas if any or all of the areas is
armed or not ready. Refer to the following examples:
All 8 areas are Ready, and areas 3 and 5 are disarmed.
Flashing number on the ready line = area is ready to be Force Armed.
Flashing number on the armed line = area is armed Instant.
All areas are disarmed and ready to arm.
Ready 12345678
Armed 12-4-678
System Ready
Type code to arm
