g
EV Charging Station
User Manual & Installation Instructions
GE EV Charging Station User Manual
82 of 86
To activate charging, hold the RFID card in front of the reader for 2-3 seconds. Upon successful
authentication of that card, the reader LED will turn green after another small delay of 2-3
seconds.
4.5
Setup without RFID Authentication
Some EVSE models are not equipped with an RFID reader and are not meant to be set up in a network
environment. Even models with RFID can be used in a non-authentication mode. In both cases, the
EVSE controller settings do not need to be modified from the default values.
In order to disable the RFID authentication function from a previous networked setup, it is
recommended to either reset the EVSE controller as explained in a later chapter, or to reset the values
on the EVSE controller following the steps described in the Configuration Server Interface section, and
set the parameters as shown.
After the desired settings were configured click on “Save”.
Figure 76: Factory Default values
Note:
For authentication to work, keep the host PC connected and up and running at all
times.
Note:
It is recommended to keep track of
the different IP settings for each EVSE by
recording them on the form found on the
final page of this document.
