16
ANTI-TIP PRECAUTIONS
These products are heavy at the top and must be
secured to prevent the possibility of tipping over.
• Mount brackets provided using #12 or #14 wood
screws located 83-1/2" from the finished floor.
• Screws must be driven at least one inch into vertical
wall studs.
• Attach a 71" long 2x4 block to brackets as shown.
Roll Both Products into Opening
• Gently push each product into opening with hands
against front corners. Push back into the opening until
it is flush or semi-flush with adjacent cabinets.
Step 2
Install
Anti-Tip
Brackets
Step 3
Level Both
Products
Both products MUST BE LEVEL AND PLUMB with each
other and adjacent cabinetry on each side.
Toekick
heights should align with cabinetry.
• Adjust carefully. Both models have 4-point leveling.
The front is supported by leveling legs, the rear is
supported by wheels.
• Raise units to the same level, aligning with adjacent
toekick heights.
• Adjust rear wheels beneath the product to just barely
touch the 2x4 block.
• Turn the 7/16" hex nut located above the front wheels
to raise or lower the back of the refrigerator.
• To adjust the front leveling legs: Use a 1/4" angled
wrench to turn the top of the leveling leg, or, turn the
bottom of the legs with a 1-1/2" wrench.
Step 4
Secure
Products
To Sides
Note:
This step can be used
as an alternative to Step 2,
Anti-Tip bracket installation,
whenever brackets cannot
be used. Whenever
possible, perform this step
for additional anti-tip
security.
OR
CAUTION
WARNING
Important Note:
When the products are installed under
a soffit or if there is not enough height for this method
of security, use Step 4 as an alternative.
The refrigera-
tor and freezer must be secured to prevent tipping.
PRECAUTIONS CONTRE LES BASCULEMENTS
Le réfrigérateur est beaucoup plus lourd en haut et
il faut le maintenir en place pour éviter la
possibilité de son basculement vers l’avant.
ATTENTION
Block
Soffit
Side View
Side View
83-1/2"
From
Floor
to
Bottom
of Wood
Block
Leveling Leg
Hex Nut Adjusts
Rear Wheels
Stud
Spacer
Block
Refrigerator
Cabinet
Door
Units must be 1" apart and evenly aligned at top and
bottom. The inside case trims must align, top and
bottom.
When using 1/2" to 3/4" thick side panels, the front
flange of the case trim is attached to the side panel.
• Open door to access case trim.
• Drill hole in trim slightly below the interior opening.
• Drive screw through the trim and into the side panel.
• Follow the same procedure on the opposite outside
product trim.
If the product is installed between cabinets with no
side panels or into a custom enclosure, install a spacer
block as shown.
ZUGSS Trim Kit
Unified Stainless Steel Grille Panel
Mounting Bracket
2 x 4 Cut
To 71"
Length
83-1/2" From Floor
Wood Screws Mounted into
Vertical Wood Studs
