www.led.com
GE and the GE Monogram are trademarks of the General Electric Company. All other trademarks are the property
of their respective owners. Information provided is subject to change without notice. All values are design or typical
values when measured under laboratory conditions. GE Lighting and GE Lighting Solutions, LLC are businesses of
the General Electric Company. © 2019 GE.
IND533 (Rev
10
/
23
/19)
Electrical Connections
Carefully remove knockout for AC line input
wires. Install listed electrical fittings in the
knockout holes for wire protection.
1
Connect the AC line to the black (line) and
white (neutral) input wires of the LED driver.
Connect the ground wire to the
green-yellow ground wire of the LED driver.
When connecting the dimming control
wires, they must run through a separate
knockout hole. Wiring requires an
appropriate wire restraint.
2
Secure the enclosure cover with the captive screw that is attached to the cover after wiring is complete.
3
Option for Step 2: Follow diagram for 0-10V. Run wires from controller through a different knockout than
the AC input wire. At output side of fixture, make appropriate connections using twist-on wire connectors.
To combine with LFAMBA0VQFAEL, LCAMBA0NRFAEL, LCAMBA0TSFAEL, LCAMBA0TQFAEL, LFAMBADVQFA,
LCAMBA0NRFAB2, LCAMBA0TSFAB2, LCAMBA0TQFAB2, LCAMBA0NRFA, LCAMBA0TSFA, LCAMBA0SQFA or
LCAMBA0TQFA, please follow the install instructions provided with those products.
4
NOTE
: Please cover dimming leads with wire nuts if you will not connect with dimming leads.
AC Line
To dimming controller
