GE KTD-405, Руководство пользователя

Страница: 71 / 76

Appendix A
Sample configurations and charts
67
Reprogrammable keys and commands
From the supervisor programming mode you can reprogram any of the soft keys with any of the available
commands.
Note: Holding the seq key for three seconds returns you to the normal operating display, except on displays where esc is
required to exit.
To reprogram soft keys, do the following:
Figure 76. Keys that can be reprogrammed
1. Beginning at the normal operating display,
enter the supervisor programming mode by
pressing and holding the
key.
Figure 73. Normal operating display
2. After the keypad beeps and the code entry
display appears ( Figure 74 ), quickly enter
the access code for the supervisor menus by
pressing the
1-4-7-6-seq
key sequence.
The display will automatically advance to
the next display.
Figure 74. Code entry display
3. Press the key (for NEXT) until the
PROGRAM SOFT KEYS display appears
( Figure 75 ). Press the + side of the zoom ,
focus , or iris key.
Note: Use the plus side of any of these keys for
YES and the minus side of any of these
keys for NO.
Figure 75. PROGRAM SOFT KEYS display
CAMERA 0
MONITOR 1
ENTER PROGRAMMING
CODE:
PROGRAM SOFT KEYS? _
(+)=YES (-)=NO NEXT
CAMERA 22
ZONE 32 PA
Recommended set
Complete set