12
REMOVE DUCT KNOCKOUT(S)
If
recirculating
, non-vented ductless (optional for
JV5 Series models only), see note below and
skip to
Step 11 D and proceed
.
We do not recommend the
recirculated configuration for JV6 Series models.
Using a flat blade screwdriver, remove the appropriate
duct knockout(s)
from the top or back of the hood.
3
1
⁄
4
″
x 10
″
Rectangular
vertical discharge.
Remove top rectangular
duct knockout only.
7
″
Round vertical
discharge.
Remove semi-
circular duct knockout and top
rectangular duct knockout.
3
1
⁄
4
″
x 10
″
Rectangular
horizontal discharge.
Remove
rear rectangular duct knockout only.
FOR 3
1
⁄
4
″
X 10
″
RECTANGULAR
DUCTED DISCHARGE
INSTALLATIONS ONLY:
Attach
exhaust adaptor/damper
over knockout
opening with two exhaust adaptor screws. Make sure
damper
pivot
is nearest to
top/back edge
of hood.
Remove
tape
from damper flap.
Up to 1
″
side-to-
side adjustment
Tape
Top/back edge
Exhaust adaptor/damper
(vertical discharge position
shown)
Pivot
FOR 7
″
ROUND VERTICAL
DUCTED DISCHARGE
INSTALLATIONS ONLY:
Re-install the
7
″
round exhaust adaptor
with its
screws, removed in Step 2 under the “Prepare the
Hood” section.
8
9
10
7
″
round
exhaust
adaptor
NOTE:
The 7
″
round exhaust adaptor can be installed
up to 1
″
on either side of the hood center to
accommodate off-center ductwork. In extreme off-center
installations, one end of the duct connector may need
to be trimmed to clear the electrical cable clamp.
Installation Instructions
NOTE:
The exhaust adaptor/damper can be installed
up to 1 inch on either side of the hood center to
accommodate off-center ductwork. In extreme off-
center installations, one end of the duct connector may
need to be trimmed to clear the electrical cable clamp.
NOTE:
If the hood is to be installed in a
recirculating
,
non-vented ductless manner, order kit number
WB02X10707 for 30
″
hood models, or kit number
WB02X10708 for 36
″
hood models. These kits can
be ordered from your GE supplier.
Skip to Step 11 D
and proceed
.