GE JSP50GN Скачать руководство пользователя страница 32

Страница: 32 / 48

and

(continued)

Solid Disk Element
Module

Solid disk elements are easy
clean because the element is raised
above the

and sealed to it.

Food spills cannot

under the

cookware or the element. Spills
stay on the module surface where
they cool and are easy to wipe up.

Be sure the controls are off and
the module and elements are cool
before handling or cleaning. The

cool slowly and do not

coil elements do

when they are hot.

The trim rings around the elements
are stainless steel and may be
cleaned with stainless steel
cleaner.

When cleaning solid elements:

●

Rub in the direction of the

circular ridges.

●

Rinse completely and wipe dry.

●

Turn elements on to dry

completely and prevent rust.

●

After the elements have been

cleaned, heated to dry and cooled,

wish to use a paper

to apply a small amount of non-
stick, salt-free cooking oil. Use a
clean paper towel to remove any
excess oil. Expect a little smoking
the next time the elements are

turned on.

Disk Care Tips

The solid elements can be cleaned
with scouring powder or a

scouring

pad the same way as

cleaning a cast-iron skillet.

If the elements have been scoured

or if they appear dull, oil them
when cool with a non-stick,

free cooking oil. Oiling the

elements from time to time will

maintain their good appearance
and help protect them from rust.

It is normal for cast iron to lose its
luster as it ages. This will not
affect performance or durability of
the element.

You can also buy products (such as
EGO

or Rutland Paste”)

restore appearance of the solid

elements. Follow the manufacturers’
instructions on the packages.

The red dot in the center of each
element can be removed by

scouring. The dot is for factory
identification only and removing it
will not affect performance or
durability of the element.

Because the elements are cast iron,
they should be kept dry to prevent
rust. Be sure the bottom of your

pan is dry before you put it on the
element. After cleaning the
elements, turn them on a few
minutes to completely dry them.

Radiant Module

With proper care and cleaning,
the radiant module will give you
efficient and satisfactory service.

Remove soiling mineral deposits
from evaporated water spills or
metal rub-off from aluminum
cookware. Otherwise, it will burn
on the surface and cause
permanent discoloration. Follow
directions below carefully in

caring for your module to assure
safe and proper maintenance.

Be sure that controls are turned off
and the module is cool before
cleaning.

Radiant Module Glass Top

Wipe glass clean after each use.

Use an all-purpose, non-abrasive
cleaner. Do not use a dish towel or

sponge to wipe up the module.
They may leave a film of detergent
which can discolor the module
when heated. If this happens,
remove the film with the
recommended cleaner. We
recommend that you use paper
towels or a clean cloth which is
used only for cleaning the module.
Melted materials can cause
permanent damage to the module.

If you accidentally melt anything
onto the module, or boil over foods
with high sugar content, remove it
immediately before the module

cools. Use a razor blade scraper
held carefully with a pot holder;
don’t use a wet sponge or cloth

because these can cause steam
burns.

For burned-on spillover:

Remove excess soil with

single-edged razor blade scraper.
Hold the blade at about a 30° angle
to the glass surface and scrape off
the soil.

●

Scrub with a cooktop cleaning

cream available at Sears or you can
order it by writing to:

ELCO Sales
2545 Palmer Avenue
University Park, IL 60466

●

Never use abrasive scouring pads