GE JSP28, Инструкция по использованию и уходу

Страница: 32 / 36

QUESTIONS?
USE THIS PROBLEM SOLVER
PROBLEM
“F-” AND A NUMBER
FLASH IN THE DISPLAY
OVEN WILL NOT WORK
OVEN LIGHT
DOES NOT WORK
FOOD DOES NOT
BROIL PROPERLY
FOOD DOES NOT ROAST
OR BAKE PROPERLY
CLOCK AND
MINUTE/SECOND
TIMER DO NOT WORK
SURFACE UNITS NOT
FUNCTIONING PROPERLY
OVEN WILL NOT
SELF-CLEAN
DOOR WILL NOT OPEN
AFTER SELF-CLEAN CYCLE
CONTROL SIGNALS AFTER
ENTERING OVEN TIME
OR STOP TIME
OVEN TEMPERATURE TOO
HOT OR TOO COLD
“BURNING” OR “OILY”
ODOR EMITTING FROM
OVEN WHEN TURNED ON
STRONG ODOR
If your
need more help... call,
GE Answer Center”
800.626.2000
consumer information service
POSSIBLE CAUSE
●
This is function error code. Press the CLEAR/OFF pad. Allow the oven to cool
one hour. Place the oven back into operation. If function error occurs again,
disconnect power to the oven and call for service.
●
The plug on the range is not completely inserted in the electrical outlet.
●
The circuit breaker in your house has been tripped, or a fuse has been blown.
●
The oven controls are not properly set.
●
The light bulb is loose or defective. Tighten or replace.
. The switch the oven is broken. Call for service.
●
Oven controls not set properly. See the Broiling section.
●
Door not left open to the broil stop position as recommended.
●
Improper shelf position being used. See the Broiling Guide.
●
Food is being cooked on a hot pan.
●
Cookware is not suited for broiling.
Aluminum foil used on the broiler pan and rack has not been fitted properly
and slit as recommended.
●
Oven controls not set properly. See the Baking or Roasting section.
●
Shelf position is incorrect. See the Roasting or Baking section.
●
Incorrect cookware or cookware of improper size is being used
●
Oven thermostat needs adjustment. See the Adjust the Oven
It Yourself section.
●
A foil tent was not used when needed to slow down browning during roasting.
●
Make sure electrical plug is plugged into a live, properly grounded power outlet.
●
Check for a power outage.
●
See the Oven Control, Clock and Timer section.
●
Surface units are not plugged in solidly.
●
Surface unit controls are not set.
●
Oven temperature is too high to set self-clean operation.
Allow the to cool to room temperature and reset the controls.
●
When the temperature has fallen below the locking temperature
door can be opened.
●
This is reminding you to enter a bake temperature.
●
Oven thermostat needs adjustment. See the Adjust the Oven
It Yourself section.
●
This is normal in a new oven and disappear in time.
●
An odor from the insulation around the inside of the oven is normal for the
first few times the oven is used. This is temporary.
free:
—
32