Painted Surfaces
Painted surfaces include the top and
sides of the door, and the drawer front.
Clean these with soap and water or
a vinegar and water solution.
Do not use commercial oven cleaners,
cleaning powders, steel wool or harsh
abrasives on any painted surface.
26
Consumer Support
Tr
oubleshooting T
ips
Care and Cleaning
Operating Instructions
Safety Instructions
Care and cleaning of the range.
Oven Vent and Cooktop Air Inlet
The oven is vented through an opening
in the cooktop under the grille. The
cooktop takes in air through the air inlet
located through the cooktop.
Never cover these openings with
aluminum foil or any other material.
This would prevent the vents from
working properly.
Control Panel
If desired, the touch pads may be turned off
before cleaning.
See the
Control Lockout
section.
Clean up splatters with a damp cloth.
Remove heavier soil with warm soapy
water. Do not use abrasives of any kind.
Turn on the touch pads after cleaning.
Removable Oven Floor
To remove the oven floor for easier
cleaning:
Remove the oven door using the
instructions in the
Lift-Off Oven Door
section.
Grasp oven floor at the rear finger
slots on each side, lift it up, push it
back and pull it out.
Clean the oven floor with warm
soapy water.
IMPORTANT:
Always replace the
removable floor before the next use.
Oven floor
Oven vent
Do not use a steel-wool pad; it will
scratch the surface.
Shake bottle well.
Place a small amount of
CERAMA BRYTE
®
Stainless Steel
Cleaning Polish and Conditioner
on a
dry
cloth or
dry
paper towel.
Clean a small area
(approximately 8
″
x 8
″
), rubbing
with the grain of the stainless steel
if applicable.
Dry and buff with a clean, dry
paper towel or soft cloth.
Repeat as necessary.
Stainless Steel Surfaces
(on some models)
To order:
To order CERAMA BRYTE
®
Stainless
Steel Cleaning Polish and Conditioner,
please call our toll-free number:
National Parts Center. . 800.626.2002
www.GEAppliances.com
CERAMA BRYTE
®
Stainless Steel Cleaning Polish
and Conditioner . . . . . . # PM10X313
Cooktop air inlet