GE JGSP23, Руководство по установке

Страница: 16 / 38

16
Adjusting the Cooktop Burners Low Flame Setting
Installation Instructions
Making the L.P. Gas Conversion
J4
a. Remove the valve control knobs.
b. Through the opening, insert small screwdriver through access hole in valve switch.
Engage adjustment screw in valve. Screw down fully, in the clockwise rotation, the
by pass screw.
Low setting adjustments must be made with two other burners in operation on a medium
setting. This procedure prevents the low flame from being set too low resulting in the flame
being extinguished when other burners are turned on.
J
HIGH OUTPUT
CAUTION: The following adjustments must be made before turning on the gas to the burner.
Failure to do so could result in serious injury due to high flames and toxic fumes.
BAKE BURNER
1. Remove the oven bottom.
2. Remove the two screws securing burner baffle (flame spreader).
3. Remove the burner baffle (flame spreader).
4. Remove the orifice fitting cover.
Adjusting the Oven Burners
J5
2 Screws
IMPORTANT: Do not overtighten or you may bend the orifice hood or needle.
5. Use a 1/2" open end or adjustable wrench to turn the
orifice hood in the L.P. direction, about one and one-half
turns, until snug.
BROIL BURNER
Use a 1/2" open end or adjustable wrench to turn the orifice hood in the L.P.
direction, clockwise about one and one-half turns, until snug.
Air Shutter
Screw
Orifice Fitting
Cover
Air Shutter
NAT. - LP.
ADJUSTMENT
MADE TO ORIFICE HOOD
L.P.
NAT.
Air
Shutter
Screw
Air Shutter
NAT.
L.P.