GE JGSP20GEP, Инструкция по использованию и уходу

Страница: 28 / 32

Anti-Tip Device Installation Instructions
for Kit No. 045 (344119)
WARNING
●
ALL RANGES CAN TIP
●
INJURY COULD RESULT
●
INSTALL ANTI-TIP
DEVICE PACKED
WITH RANGE
●
SEE INSTRUCTIONS
1. Before placing range in the
counter, notice the location of the
stability bracket which is already
attached to the back of the
Long Screw
Bracket
2. Fasten one end of the stability
4. Place the range in the counter
chain to the floor or the wall with
the long screw and washer supplied.
Make certain the screw is going
This location should work for-most
into the wall at the base of the
installations. However, it maybe
more convenient to hook the
stability chain the unit when the
stability bracket is attached to the
upper set of holes in the back of the
range (see Fig. 2).
Make sure there are no structural
supports for the countertop that
will interfere with the stability
bracket when located in the upper
set of holes. Determine where the
gas plumbing is located behind the
range so the chain and bracket will
in no way damage the plumbing.
wall or one studs in the wall
(see Fig. 1). Whether you attach the
chain to the wall or floor, be certain
that the screw is in at least 3/4”
thickness of wood other than
baseboard and that there are no
electrical wires or plumbing in the
area that the screw could penetrate.
Attach the stability chain in a
location that will allow it to be in
line with the bracket side-to-side as
much as possible when attached to
the unit. Test to see if the chain is
securely fastened by tugging on it.
3. Temporarily attach the loose end
of the chain to the rear of the
countertop with the tape from the
packaging (see Fig. 1).
cutout leaving just enough room
between the back of the range and
the wall to reach the stability
bracket.
5. Hook the loose end of the chain
onto the bracket by slipping the
nearest link of the chain into the
slot in the bracket (see Fig. 2),
making sure the chain is pulled as
tight as possible and that there is no
excess slack in the chain after chain
is attached to the bracket.
Excess slack in the chain could
allow the range to tip over
excessively.
6. Slide the range all the way back
into the counter cutout. Once the
range is pushed back in
there
will be a small amount slack in
the chain. This is normal.
28