GE JGP932, Руководство по установке

Страница: 14 / 32

14
Installation Instructions
MAKING THE LP CONVERSION
(CONT.)
CHANGE THE COOKTOP
BURNER ORIFICES
Remove the top grates, burner caps,
burner heads and burner bases.
Remove the
electrodes from the
burner base. Using a
No. 15 “Torx” head
driver bit, remove the
screws holding the
burner base in
position.
Using a 7mm or
9/32
″
nut driver,
remove the top
burner orifices.
These may be
accessed through the
hole in the cooktop.
NOTE: The orifices have
a spring loaded retaining
ring around the hex head
to hold the orifice in
the nut driver during
installation and removal.
A slight amount of force is required to push
the nut driver down over the ring.
Locate the LP/Propane orifices shipped
inside the literature package. They
will have a digit number and the letter
“L” on the side.
(Important: Save the
orifices removed from the appliance
for future use.)
Each orifice will show a series of
engraved marks, (I, II, III or X), located
on the top.
These marks denote the precise location of
each orifice to the cooktop burner.
D
C
B
A
3
Units with 1500 BTU/HR burner on right front.
(See rating plate on bottom of appliance.)
Units with 9100 BTU/HR burner on right front.
(See rating plate on bottom of appliance.)
Install the LP/Propane orifices in
their precise locations as noted in the
illustrations above.
Return the natural orifices to the
bracket and reattach the bracket and
the instruction sheet to the pressure
regulator using the screw previously
removed.
Replace the burner bases, heads,
caps and top grates. (
NOTE: When
re-attaching the burner bases to glass
top units, tighten screws to a maximum
of 10 in.-lbs torque.)
G
F
E
I II III X
III
II
I
X
II
II
I
II
Remove
This
Assembly
Orifice Spud Located
Thru This Opening
Retainer
Ring