Operating
Instructions
Safety
Instructions
Installation
Instructions
Tr
oubleshooting
Tips
Consumer
S
uppor
t
48
Before you call for service…
Problem
Possible Causes
What To Do
Excessive smoking
Excessive soil.
• Touch the
Clear/Off
pad.
Oven door will not open
Oven too hot.
• Allow the oven to cool below locking temperature.
after a clean cycle
Oven not clean after
Oven controls not properly set.
• See the
Using the self-cleaning oven
section.
a clean cycle
Oven was heavily soiled.
• Clean up heavy spillovers before starting the clean cycle.
Heavily soiled ovens may need to self-clean again or for
a longer period of time.
Oven door will not
Oven is too hot.
• Allow the oven to cool below locking temperature.
unlock (on models
Do not lock the door with the door latch except when
with a door latch)
using the self-clean feature.
Self clean light blinks
A power interruption occurred.
• Touch the
Clear/Off
pad, wait for the oven to cool, and
during self clean cycle
on models with a latch, move it to the left as far as
it will go. Reset the range controls to the desired
settings. See the
Using the self-cleaning oven
section.
Self-cleaning cycle has been
• Close the oven door. On models with a latch, move it all
selected, but the oven door was
the way to the right.
not closed, and on models with a
latch, it was not moved all the
way to the right.
On models with a latch, it
• Move the latch handle to the right only when setting
was moved to the right, but a
the self-cleaning cycle.
program other than self-cleaning
was selected.
“F—and a number or
On models with a door latch,
• The latch may have been moved, even if only slightly,
letter” flash in the
if a function error code appears
from the locked position. Make sure the latch is moved
display
(on some models)
during the self-cleaning cycle,
to the right as far as it will go.
check the oven door latch.
You have a function error code.
• Touch the
Clear/Off
pad. Allow the oven to cool for
one hour. Put the oven back into operation.
If the function code repeats.
• Disconnect all power to the range for 5 minutes
and then reconnect power. If the function error
code repeats, call for service.
Troubleshooting Tips
