Installation Instructions
LOCATION
Do not locate the range where it may be subject to
strong drafts. Any openings in the floor or wall behind
the range should be sealed. Make sure the openings
around the base of the range that supply fresh air
for combustion and ventilation are not obstructed
by carpeting or woodwork.
Your.range,.like.many.other.household.items,.is..
heavy.and.can.settle.into.soft.floor.coverings.such.as.
cushioned.vinyl.or.carpeting ..Use.care.when.moving..
the.range.on.this.type.of.flooring ..It.is.recommended.
that.the.following.simple.and.inexpensive.instructions.
be.followed.to.protect.your.floor .
The.range.should.be.installed.on.a.sheet.of.plywood..
(or.similar.material) ..When.the.floor.covering.ends.at.
the.front.of.the.range,.the.area.that.the.range.will.rest.
on.should.be.built.up.with.plywood.to.the.same.level.or.
higher.than.the.floor.covering ..
This.will.allow.the.range.to.be.moved.for.cleaning..
or.servicing ..Also,.make.sure.your.floor.covering.will.
withstand.180°F ..(See.the.Installation.Safety.Instructions.
section .)
Make.sure.the.wall.coverings.around.your.range.can.
withstand.the.heat.generated.(up.to.200°F).by.the.
range ..(See.the..
Installation Safety Instructions
.section .)
IMPORTANT!
Remove.all.tape.and.packaging ..Make.sure.the.burners.
are.properly.seated.and.level .
Take.the.accessory.pack.out.of.the.oven.and/or.drawer .
Check.to.be.sure.that.no.range.parts.have.come.loose.
during.shipping .
38
CONVERTING TO LP GAS
(or converting
back to natural gas from LP)
This range leaves the factory set for use with natural
gas. If you want to convert to LP gas, the conversion
must be performed by a qualified LP gas installer.
The.conversion.instructions.and.LP.orifices.can.be.found.
attached.to.the.range.next.to.the.pressure.regulator .
Keep.these.instructions.and.the.orifices.in.case.you.want.
to.convert.back.to.natural.gas .
Your range is designed to operate at a pressure of 5”
of water.column.on.natural.gas.or,.if.designed.for.LP.gas.
(propane.or.butane),.10”.of.water.column .
Make.sure.you.are.supplying.your.range.with.the.type..
of.gas.for.which.it.is.designed ..
This.range.is.convertible.for.use.on.natural.or..
propane.gas ..If.you.decide.to.use.this.range.on.LP.gas,.
conversion.must.be.made.by.a.qualified.LP.installer.
before.attempting.to.operate.the.range.on.that.gas .
For.proper.operation,.the.pressure.of.natural.gas.supplied.
to.the.regulator.must.be.between.5
”
.and.13
”
.of.water.
column ..
For.LP.gas,.the.pressure.supplied.must.be.between.10
”
.
and.13
”
.of.water.column ..
When.checking.for.proper.operation.of.the.regulator,..
the.inlet.pressure.must.be.at.least.1".greater.than.the.
operating.(manifold).pressure.as.given.above ..
The.pressure.regulator.located.at.the.inlet.of.the.range.
manifold.must.remain.in.the.supply.line.regardless.of.
whether.natural.or.LP.gas.is.being.used ..
A.flexible.metal.appliance.connector.used.to.connect.the.
range.to.the.gas.supply.line.should.have.an.I .D ..of.1/2
”
.
and.be.5.feet.in.length.for.ease.of.installation ..In.Canada,.
flexible.connectors.must.be.single.wall.metal.connectors.
no.longer.than.6.feet.in.length .
PROVIDE ADEQUATE GAS SUPPLY
1