Consumer Support
Tr
oubleshooting T
ips
Care and Cleaning
Operating Instructions
Safety Instructions
Troubleshooting Tips
40
Problem
Possible Causes
What To Do
Clock and timer do
Plug on range is not completely
•
Make sure electrical plug is plugged into a live, properly
not work
inserted in the electrical outlet.
grounded outlet.
A fuse in your home
•
Replace the fuse or reset the circuit breaker.
may be blown or the
circuit breaker tripped.
Oven controls improperly set.
•
See the
Using the clock and timer
section.
Oven will not self-clean
The oven temperature is
•
Allow the range to cool and reset the controls.
too high to set a self-clean
operation.
Oven controls improperly set.
•
See the
Using the self-cleaning oven
section.
The probe is plugged into
•
Remove the probe from the oven.
the outlet in the oven.
(on some models)
“Crackling” or
This is the sound of the
•
This is normal.
“popping” sound
metal heating and cooling
during both the cooking and
cleaning functions.
Excessive smoking
Excessive soil.
•
Touch the
CLEAR/OFF
pad. Open the windows to
during a clean cycle
rid the room of smoke. Wait until the
LOCKED
light
goes off. Wipe up the excess soil and reset the clean
cycle.
Oven door will not
Oven too hot.
•
Allow the oven to cool below locking temperature.
open after a clean cycle
Oven not clean after a
Oven controls not properly set.
•
See the
Using the self-cleaning oven
section.
clean cycle
Oven was heavily soiled.
•
Clean up heavy spillovers before starting the clean
cycle. Heavily soiled ovens may need to self-clean
again or for a longer period of time.
“LOCKED” flashes
The self-clean cycle has been
•
Close the oven door.
in the display
selected but the door is not
closed.
“LOCKED” light is
The oven door is locked
•
Touch the
CLEAR/OFF
pad. Allow the oven to cool.
on when you want
because the temperature
to cook
inside the oven has not
dropped below the
locking temperature.
“F—and a number
You have a function error code.
•
Disconnect all power to the range for at least 30
or letter” flash
seconds and then reconnect power. If the function
in the display
error code repeats, call for service.
Before you call for service…