METHODS OF SAFE INSTALLATION
1. SAFE INSTA L L ATION PLACE FOR YOUR REFRIGERATO R
4
Place the refrigerator on
hard and level floor.
Place your refrigerator
where there is no heat
source nearby.
High surrounding
temperature will lower
cooling efficiency and
increases your electricity
Place the refrigerator in
an area with low
m o i s t u r e .
Splashing water or a
high moisture area may
cause a short circuit and
make rusting easier.
Avoid places that are
exposed to smoke.
The discoloring can
occur to the refrigerator.
For good ventilation
place refrigerator with
the spaced specified on
the figure.
This helps cooling
efficiency and lowers the
electricity bill.
Placing the refrigerator
on the carpet may cause
heat to develop and
discolor the appliance. In
such a case put a hard
wooden board or a
rubber mat between the
refrigerator and the
c a r p e t .
HOW TO OPERATE
1. TEMPERATURE CONTROL
3
Temperature is controlled by thermostat automatically.
The Temperature Control inside the refrigerator controls the degree of
cooling for each compartment.
Freezer Temperature Control
The control has four settings form
LOW to WINTER. The WINTER
mode is available only if atmosphere
temperature is below 10°C.
Refrigerator Temperature Control
The control has the four settings from
LOW to WINTER. The WINTER mode
is available only if atmosphere
temperature is below 10°C.
Starting your new refrigerator
To control temperature
Many factors may influence the internal temperature of the refrigerator
and freezer compartments.
■
The temperature and humidity of the surrounding environment.
■
The opening frequency of the doors and the amount of warm food placed in
the refrigerator.
■
The combination of food and containers stored in the refrigerator.
For these reasons, you may want to adjust the control to suit the season and your needs.
1. Clean the refrigerator thoroughly. Wipe the outside with a dry cloth, and the inside
with a damp cloth.
2. Set the temperature control knob at normal position.
3. Connect the power supply cord.
