GE GSD6000 Series Скачать руководство пользователя страница 3

Страница: 3 / 12

Installation Preparation

PREPARE DISHWASHER ENCLOSURE

• The rough cabinet opening must be at least 24" deep, 24"

wide and approximately 34-1/2" high from ﬂ oor to underside
of the countertop.

• The dishwasher must be installed so that drain hose is no

more than 10’ in length for proper drainage.

• The dishwasher must be fully enclosed on the top, sides and

back, and must not support any part of the enclosure.

WARNING

To reduce the risk of electric shock, ﬁ re, or injury to persons, the

installer must ensure that the dishwasher is completely enclosed

at the time of installation.

CLEARANCES:

When

installed into a corner,
allow 2" min. clearance
between dishwasher and
adjacent cabinet, wall or
other appliances. Allow
28-3/8" min. clearance
from the front of the
dishwasher for door
opening.

Figure B

DRAIN REQUIREMENTS

• Follow local codes and ordinances.
• Do not exceed 10’ distance to drain.

NOTE:

Air gap must be used, if waste tee or disposer

connection is less than 18" above floor, to prevent siphoning.

DETERMINE DRAIN METHOD

The type of drain installation depends on the following
questions.

■

Do local codes or ordinances require an air gap?

■

Is waste tee less than 18" above floor?

If the answer to either question is YES, Method 1 MUST

be used.

• If the answers are NO, either method may be used.

CABINET PREPARATION

• Drill a 1-1/2" diameter hole in the cabinet wall within

the shaded areas shown in Figure A for the drain hose
connection. The hole should be smooth with no sharp edges.

IMPORTANT:

When connecting

drain line to disposer, check to be
sure that drain plug has been
removed. DISHWASHER WILL NOT
DRAIN IF PLUG IS LEFT IN PLACE.

Remove

Drain

Plug

923-10N

Method 1 – Air Gap with Waste Tee or Disposer

An air gap must be used when required by local codes and ordinances.
The air gap must be installed according to manufacturer’s instructions.

Method 2 – Built-in “High Drain Loop” with Waste Tee or Disposer

Note:

Avoid unnecessary service call charges. Always be

sure disposer drain plug has been removed before attaching
dishwasher drain hose to the disposer.

Figure C

Figure D

Figure B

��

��

��

��

��

��
��

��

Figure A

923-40A

32"

Min.

18"

Min.

Drain Hose Hanger

923-40B

32"

Min.

18"

Min.

Drain Hose Hanger

Содержание GSD6000 Series













Результаты поиска

Содержание GSD6000 Series

Отзывы:

Бренды по названию

Популярные бренды

GE GSD6000 Series, Руководство по установке

Результаты поиска

Содержание GSD6000 Series

Отзывы:

Бренды по названию

Популярные бренды