GEAppliances.com
9
7
10
Ext Tumble/Wrinkle Care
Minimizes wrinkles by adding approximately 60
minutes of no-heat tumbling after clothes are
dry. The beeper will sound every five minutes as a
reminder to remove the clothes.
The estimated time remaining display will show
“0:00”.
The extended tumble time does not get added to
the cycle time on the display.
11
Damp Alert
This option causes the dryer to beep when clothes
have dried to a damp level. Remove items that you
wish to hang dry. The
Damp Alert
will only beep
when this option is selected, and the dryer will
continue to dry.
Removing clothes and hanging them when they are
damp can reduce the need to iron some items.
Delay Dry
Use to delay the start of your dryer.
1. Choose your dry cycle and any options.
2. Press
Delay Dry
. You can change the delay time
in 1 hour increments up to 24 hours, using the
Delay Dry
button.
3. Press the
Start/Pause
button to start the
countdown.
NOTE:
If the door is opened while the dryer is in
Delay Dry
, the countdown time will not restart
unless the door is closed and
Start/Pause
button
has been pressed again.
Volume
Alerts you that the cycle is complete. The beeper
will continue to sound every minute for the next 5
minutes, until the clothes have been removed. The
clothes should be removed when the beeper goes
off so wrinkles don’t set in.
Press
Volume
to select low, medium or high volume,
or to turn the beeper off.
To turn on or off the sounds the buttons make
when pressed, press and hold the
Volume
button
for 3 seconds.
Lock Control
You can lock the controls to prevent any
selections from being made. Or you can lock
or unlock the controls after you have started a
cycle.
Children cannot accidentally start the dryer by
touching buttons with this option selected.
To lock the dryer, press and hold the
Lock
Control
button for 3 seconds.
To unlock the dryer controls, press and hold the
Lock Control
button for 3 seconds.
A sound is made to indicate the lock/unlock
status.
The indicator light above the button will
illuminate when the controls are locked.
NOTE
: The
Power
button can still be used when
the machine is locked.
12
13
14
Clean Filter Message
This message represents only a reminder and does
not
always appear when the filter needs cleaning.
The filter should be cleaned after every drying cycle
is complete.
This message will disappear after the
Start/
Pause
button is pressed. Even though you may
have already cleaned the filter (before or after the
Power
button has been pressed), the “
Clean Filter
”
message will still be displayed until the
Start/Pause
button is activated.
15
Display
Displays the approximate time remaining until
the end of the cycle.
As the cycle begins, you will see an initial
approximate total cycle time in the display.
Then lights will “race” in the display. This means
the dryer is continuously monitoring the amount
of moisture in the load. The lights will continue
until the dryer senses a low level of moisture in
the load. At that point, the dryer will calculate
and display the approximate time remaining.
