GE GBS20KB, Дополнение к инструкции по установке

Страница: 5 / 8

5
Installation Instructions
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
•
CAUTION –
Unplug the
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator
from its electrical outlet.
WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS
Flat blade and Phillips
screwdrivers
Pliers
TOOLS YOU WILL NEED
Sharp knife
1/4
″
and 5/16
″
Nutdrivers
REMOVE THE COVER
At the bottom rear of the refrigerator, remove the
screws holding the access cover.
Bend the cover back to access the compartment.
Be sure to save the screws as the access cover must
be reinstalled later to ensure that your refrigerator
will function properly.
1
CUT PLASTIC WATER TUBING
•
Measure 25
″
(64 cm) of water tubing starting
from where it is secured to the water valve.
Cut off excess tubing with a sharp knife or
single-edge razor blade.
2
25
″
(64 cm)
Tape measure
• Fasten the water valve to the cabinet by driving
the
hex-head screw (8) from the kit into the
hole in the cabinet leg.
ATTACH THE WATER VALVE
• Locate the
female connector plug
(C).
3
• Plug the
female connector
(C) onto the
male
terminals on the water valve (3). Either wire
can go on either terminal.
C
3
8
C
Cabinet
Water valve
bracket
Hex-head
screw